Key takeaways
- Landlords must assess and control legionella risk, but HSE says this does not require an in-depth, detailed assessment[1].
- Most landlords can assess the risk themselves; there is no legal requirement for a legionella test certificate[1].
- Temperature is the main control: HSE cites hot water stored at 60°C and supplied to outlets at 50°C[1].
- Empty periods are the highest-risk moment, so flush outlets before a new tenant moves in[1].
What the duty really involves
Landlords who provide water in a rented home have a duty to assess the risk from legionella bacteria and to control it. The bacteria grow in water held at the wrong temperature, especially where it stagnates, and they can cause Legionnaires' disease when people breathe in contaminated droplets, most often from a shower.
The good news for agents and landlords is that the duty is proportionate. The Health and Safety Executive says it does not require an in-depth, detailed assessment, and that most landlords can assess the risk themselves without professional training or accreditation[1]. Those who do not feel competent, or would rather not, can arrange for someone else to do it. What the law does not require is a legionella test certificate; HSE is explicit that there is no such legal requirement[1]. Agents who are sold one as a compliance must-have should push back.
Source: Health and Safety Executive, 2026[1]
Show the data
| Item | Value |
|---|---|
| Stored in the cylinder or calorifier | 60 °C |
| Supplied to outlets | 50 °C |
A proportionate assessment in six steps
For a typical flat or house with a combination boiler or a small hot water cylinder, a sensible assessment fits on one page. Use the same template across the portfolio so every file looks alike.
Describe the system
Note whether hot water comes from a combination boiler, a cylinder, or a communal system, and whether there is a cold water storage tank in the loft.
Look for stagnation
Identify outlets that are rarely used, such as an outside tap, a second shower or a utility sink, and any pipework that leads nowhere after alterations.
Check temperatures
Where there is a cylinder, check the thermostat setting. HSE cites stored hot water at 60°C and water supplied to outlets at 50°C[1].
Inspect tanks and showers
Check any cold water tank has a fitted lid and is clean; look at showerheads for scale.
Consider the occupants
Note anyone who may be at higher risk, such as older tenants or people with health conditions, and whether the property will stand empty.
Decide the controls
Record the simple actions needed, such as removing dead legs, descaling showerheads, adjusting the cylinder thermostat or setting a flushing routine for voids.
Most assessments will find that the risk is low and the controls are simple. That is the expected result, not a sign the assessment was too light. HSE notes that the risks from hot and cold water systems in most homes are generally low because the water is used regularly.
Risk factors that change the answer
| Factor | Why it matters | Typical control |
|---|---|---|
| Hot water cylinder set too low | Bacteria can multiply in warm stored water | Set and record the thermostat; advise tenants not to change it |
| Cold water storage tank | Can warm up and collect debris | Fitted lid, periodic inspection, clean if dirty |
| Little-used outlets | Stagnant water in pipework | Remove dead legs or flush regularly |
| Showers and spray taps | Produce fine droplets that can be inhaled | Descale and clean showerheads |
| Long empty periods | Water sits still in the whole system | Flush before letting, or drain for long voids |
| Vulnerable occupants | Higher risk of serious illness | More frequent checks and clear advice |
| Large shared systems in HMOs or blocks | More pipework, more places to stagnate | Consider a competent person's assessment |
Voids: the moment that matters most
The risk rises most when a home stands empty. HSE recommends that outlets are used at least once a week to stop water stagnating, that a flushing regime or draining is considered for long vacancies, and that systems are flushed before a property is let[1].
Empty periods are a normal part of lettings. Propertymark agents reported an average void of almost four weeks in August 2026[2], and 8% of private rented dwellings in England were vacant while awaiting another tenant or owner in 2024[3]. Four weeks of still water is exactly the condition the HSE advice is aimed at.
Almost 4 weeks
average void period reported by Propertymark letting agents in August 2026[2]
Example: a two-bedroom flat with a hot water cylinder falls empty for five weeks between tenants. The property manager adds a weekly void visit to the cleaner's schedule: run every hot and cold tap and the shower for a few minutes, check the cylinder thermostat, and note the date and time on a void sheet. On the day before check-in, the shower is run again and the showerhead descaled. The void sheet goes on the tenancy file with the risk assessment.
A void-visit checklist your team can follow
Turn the HSE advice into a short sheet that anyone on the team can complete, whether it is a property manager, a cleaner or a contractor already on site. The sheet is also your evidence if a new tenant later falls ill.
- Date and time of the visit, and who carried it out.
- Every hot and cold outlet run until the water reaches its normal temperature, including outside taps and second showers.
- Showerheads checked for scale and cleaned if needed.
- Cylinder thermostat reading noted, where there is a cylinder.
- Any cold water tank lid checked for fit.
- Any leaks, drips or unusual smells reported to the property manager.
For voids longer than a few weeks, or where weekly visits are not practical, ask a plumber whether the system should be drained and refilled before the next tenancy.
Larger systems: HMOs, blocks and older houses
Shared houses and buildings with communal hot water are different. A large HMO may have long pipe runs, several bathrooms, a big cylinder and rooms that stand empty while others are occupied. A block of flats with a communal plant room has stored water serving many homes. In these settings the proportionate assessment is more detailed, and many landlords bring in a competent person to carry it out and to set the monitoring regime.
Older houses that have been altered over the years deserve a second look too. Removed bathrooms often leave capped pipes, known as dead legs, where water sits still indefinitely. Ask the plumber to remove them when other work is being done, and note the change on the assessment.
What to tell tenants
Tenants control most of the day-to-day risk once they move in, so the advice belongs in the welcome pack and the check-in conversation. HSE suggests telling tenants not to change the temperature setting on the cylinder or calorifier, to clean showerheads regularly, and to report problems with hot water to the landlord[1].
- Run showers and taps that have not been used for a week or more, for example after a holiday, before using them.
- Keep the cylinder thermostat at the setting the landlord has chosen.
- Clean and descale showerheads every few months.
- Report water that is not hot enough, or that runs warm from the cold tap.
- Tell the agent if a room or bathroom will be unused for a long period.
Records and reviews
The legal duty to record the findings of a risk assessment applies to employers with five or more employees, so many individual landlords are not strictly required to write it down. HSE still advises keeping a record[1], and for an agent managing the property it is essential: it is the only proof that the assessment happened.
Review the assessment when something changes: a new boiler or cylinder, plumbing alterations, a change of occupants who may be at higher risk, or a long void. There is no fixed review interval, so set a sensible default, such as at each change of tenant and at least every two years.
Who does the assessment on managed lets
On fully managed lets, landlords will expect the agent to arrange or carry out the assessment. In 2024, 18% of landlords in England used agent management services[4]. If your team does assessments in-house, train the property managers using HSE's material and keep the template simple. If you use a contractor, ask what you are paying for: a proportionate assessment with clear controls is useful; sampling and a test certificate for an ordinary flat usually are not.
- Put the assessment date and next review on the property record.
- Add a line for legionella controls to every void checklist.
- Include the tenant advice in the welcome pack and check-in report.
- For HMOs, communal systems and blocks, consider a competent person's assessment.
For the other safety tasks that sit alongside this one, see smoke and carbon monoxide alarm rules and fire safety in HMOs and blocks of flats.
Frequently asked questions
Do we need to test the water for legionella?
Not usually. HSE says routine testing is not normally needed for domestic hot and cold water systems, and there is no legal requirement for a legionella test certificate. Temperature checks and simple controls are the practical measure.
Does a combination boiler remove the risk?
It reduces it, because water is heated on demand rather than stored, but the risk is not zero. Little-used outlets, cold water tanks and long voids can still create problems, so the assessment is still needed.
Who is responsible if a tenant catches Legionnaires' disease?
The landlord would need to show they had assessed and controlled the risk. HSE does not routinely inspect homes, but a case could lead to investigation, so a dated assessment and void records matter.
References
Health and Safety Executive (2026). Legionella and landlords' responsibilities (opens in a new tab) ↑
Propertymark (2026). Housing Insight Report: August 2026 (opens in a new tab) ↑
Ministry of Housing, Communities and Local Government (GOV.UK) (2025). English Housing Survey 2024 to 2025: introduction and key findings (opens in a new tab) ↑
Ministry of Housing, Communities and Local Government (GOV.UK) (2024). English Private Landlord Survey 2024: main report (opens in a new tab) ↑