Key takeaways
- At least one smoke alarm is required on each storey with a room used as living accommodation[1].
- A carbon monoxide alarm is required in any room used as living accommodation with a fixed combustion appliance, excluding gas cookers[1].
- Check every alarm is working on the day the tenancy begins, and keep evidence of the test[1].
- Failing to comply with a remedial notice can lead to a fine of up to £5,000[1].
The rules since October 2022
The Smoke and Carbon Monoxide Alarm (Amendment) Regulations 2022 came into force on 1 October 2022 and tightened the duties on landlords in England[1]. They are short, and an agent should be able to explain them to a landlord in a minute.
- At least one smoke alarm must be equipped on each storey of the home where there is a room used as living accommodation[1].
- A carbon monoxide alarm must be equipped in any room used as living accommodation that contains a fixed combustion appliance, such as a gas boiler, a wood burner or an oil-fired heater. Gas cookers are excluded[1].
- Each required alarm must be checked and in proper working order on the day the tenancy begins[1].
- Landlords are responsible for repairing or replacing faulty alarms once they are told about them[1].
Local councils enforce the rules, and failure to comply with each remedial notice can lead to a fine of up to £5,000[1]. Councils set their own penalty policies within that limit, so check your local authority's approach.
Up to £5,000
fine for each failure to comply with a smoke and carbon monoxide alarm remedial notice[1]
Where alarms must go: a room-by-room check
The rules set minimums, not a design. Use them as a floor and apply judgement for the layout.
| Space | Smoke alarm | Carbon monoxide alarm |
|---|---|---|
| Each storey with a living room, bedroom, kitchen or bathroom | At least one required | Only if a fixed combustion appliance is in a living room on that storey |
| Hallway or landing on each floor | Usual location for the storey alarm | Check the guidance if a fixed combustion appliance is located there |
| Room with a gas boiler | Not specifically required | Required if the room is used as living accommodation |
| Living room with a wood burner or open fire | Storey alarm still needed | Required |
| Kitchen with a gas cooker only | Storey alarm still needed | Not required by the rules, as gas cookers are excluded |
| Basement or loft room used as a bedroom | Required for that storey | Required if it contains a fixed combustion appliance |
Two practical points help. First, a boiler in a cupboard off a living room still raises the question of whether the alarm should be in the room; a sensible approach is to fit one in the room the cupboard opens into. Second, the rules do not specify alarm type. Many landlords now choose sealed long-life battery or mains-wired interlinked alarms, which reduce the number of faults reported by tenants.
Day-one testing, evidenced
The duty to check alarms on the day the tenancy begins is the one most often argued about after a fire. The question will not be whether alarms were tested, but whether you can prove it. The guidance recommends that landlords check alarms work on the day a new tenancy starts and keep a record[1].
Test at check-in, not before
Test each alarm on the day the tenancy begins, ideally at the check-in appointment with the tenant present. A test the week before does not meet the day-one duty.
Record each alarm
List each alarm by location and type in the check-in report, with the result of the test, the time and the name of the person who tested it.
Photograph it
Take a photo of each alarm in place. A short video of the test sounding is even better.
Get the tenant's acknowledgement
Ask the tenant to sign or confirm the check-in report, which records that the alarms were tested and working.
Tell the tenant what to do
Explain how to test the alarms and that faults should be reported straight away, in writing or by phone.
For a busy branch, this is a routine task repeated every week. The average Propertymark letting branch agreed 9.92 new tenancies a month in August 2026[2], so a missed test is a matter of when, not if, unless it is built into the check-in template.
Source: Propertymark, 2026[2]
Show the data
| Item | Value |
|---|---|
| New tenancies agreed | 9.92 |
| New fully managed instructions | 2.97 |
Advising landlords on alarm type
The regulations require alarms to be equipped and working; they do not prescribe a type. That leaves agents to advise, and the right answer depends on the building and the tenants.
- Sealed long-life battery alarms remove battery faults, a frequent source of nuisance reports, and suit single lets where wiring work would be disruptive.
- Mains-wired alarms with battery back-up are standard in many newer homes and refurbishments, and are often expected in HMOs.
- Interlinked alarms sound together, so a fire on one floor wakes people on another. They are worth recommending for houses on three or more floors and for any home where bedrooms are far from the kitchen.
- Combined smoke and heat coverage, with heat alarms in kitchens, reduces false alarms from cooking that tempt tenants to remove batteries.
Record the type and expiry date of each alarm at check-in. Most alarms carry a replacement date on the casing, and planned replacement before that date is cheaper than emergency call-outs. Where an alarm sounds often because of cooking or steam, move it or change the type rather than asking the tenant to put up with it, because an alarm that annoys people is an alarm that gets disabled.
Faulty alarm reports during the tenancy
Once a landlord is told that an alarm is faulty, they must repair or replace it[1]. The regulations leave the exact timing open, but a missing or faulty alarm is a safety risk, so treat it as urgent.
- Log the report with the time and date, and how it reached you.
- Ask the tenant to try a fresh battery if the alarm takes replaceable batteries; tenants are advised to try that first.
- If the alarm still fails, or it is sealed or mains-wired, book a replacement the same or next working day.
- Record the replacement with a photo and test result.
- Tell the landlord what was done and why.
Example: a tenant texts on a Saturday evening that the hallway alarm keeps chirping. The out-of-hours line logs the message, advises the tenant to replace the battery, and finds the alarm is a sealed unit that has reached the end of its life. The handyman fits a replacement on Monday morning, photographs it, and the property manager updates the file and the landlord by noon.
Carbon monoxide: why the alarm matters
Carbon monoxide is invisible and odourless, and gas-related CO poisoning kills around 7 people a year according to the Health and Safety Executive[3]. A CO alarm is a back-up, not a substitute for the annual gas safety check, but it is often the only warning a tenant gets if a flue fails. Where a property has an open-flued boiler, a solid-fuel stove or a gas fire, check that the CO alarm is positioned in line with the manufacturer's instructions, and test it at every routine inspection.
Access and refusal
If a tenant refuses access to install or replace an alarm, a landlord is not expected to go to court to get in, but must show reasonable steps, such as written notice and a record of attempts. Keep the same kind of evidence trail you would for a gas safety check: dated letters, messages, and the engineer's or handyman's notes of failed visits.
Who does the work: agent or landlord
On managed lets, agents normally hold the day-to-day duty in practice. In 2024, 18% of landlords in England used agent management services[4], and those landlords will expect their agent to handle alarm checks, faults and replacements under an agreed spending limit. For let-only lets, the agent still usually tests alarms at check-in, because the agent is the one there on the day. Say so in the terms of business, and say who handles faults afterwards.
- Include alarm checks in every routine inspection report.
- Keep a spare stock of common alarm types with the maintenance team.
- Record alarm type, location and expiry date on the property record.
- Replace alarms before their expiry date rather than waiting for faults.
Beyond single lets
HMOs and blocks of flats carry wider fire safety duties, including fire risk assessments, fire doors and, in larger buildings, specific checking regimes. The single-let alarm rules are the minimum inside each home; they do not replace the HMO or building regime. Read fire safety in HMOs and blocks of flats for those duties, and gas safety certificates: duties for agents for the annual gas check.
Frequently asked questions
Do the rules apply to lodgers living with the landlord?
No. Accommodation shared with the landlord or the landlord's family is excluded, as are long leases and some care and health settings. Ordinary private tenancies are covered.
Is a heat alarm in the kitchen enough for that storey?
The rules require a smoke alarm on each storey with living accommodation. A heat alarm in a kitchen is a good addition, but it is sensible to fit a smoke alarm in the hallway or landing of that storey as well, so the minimum is clearly met.
Do we need a carbon monoxide alarm next to a gas hob?
No. Gas cookers are excluded from the carbon monoxide alarm requirement. If the same room also contains a gas boiler or another fixed combustion appliance, an alarm is required.
References
Ministry of Housing, Communities and Local Government (GOV.UK) (2022). Smoke and Carbon Monoxide Alarm (Amendment) Regulations 2022: guidance for landlords and tenants (opens in a new tab) ↑
Propertymark (2026). Housing Insight Report, August 2026 (PDF) (opens in a new tab) ↑
Health and Safety Executive (2026). Domestic gas: frequently asked questions (opens in a new tab) ↑
Ministry of Housing, Communities and Local Government (GOV.UK) (2024). English Private Landlord Survey 2024: main report (opens in a new tab) ↑